Enabling N2600 Dante AV mode

Table of Contents

Question: Answer: Note:

Question:

How do I enable Dante AV mode on SVSi N2600 units?

Answer:

Enter the webpage for the device, and on the 'Stream Setup' section on the Home page, tick the 'Dante AV Mode enabled' option and hit Save. This will trigger a reboot of the device followed by Dante AV mode being enabled.

Note:

While in Dante AV Mode, stream switches will be handled by Dante Controller/Dante Domain Manager only.
Changing streams through N-Able/device webpage will not be possible or take effect.
When the devices are in Dante AV Mode, the Decoder will be a Dante Receiver only.
When not in Dante AV Mode, the Decoder can act as a Dante Receiver or Dante Transmitter (sending the SVSI audio over Dante TX).