N2600 Sendser Command Appends an Extra line Feed ($0A) to Every String
Escalation Article
Written by Richard Gregory
Updated at September 15th, 2026
Table of Contents
Brand:
- AMX
Affected Products:
- All N2600 Series
Summary:
When using Serial Commands on N2600 webpages, Executing the command or triggering it via sendser command appends an extra line feed ($0A) to every string. This can cause issues when $0A is not expected.
Troubleshooting:
Issue resolved in firmware version 1.6.9 or later.
If the procedure above did not resolve your issue, please contact HARMAN Support for next steps.