​​​​​​                             ​       

FAQ:

1. If the speaker is idle or below min. threshold, how long does it take before it goes into standby/bypass mode?

It will take 5 hours to enter standby/off mode.  The power flow chart is like this: If BT connected and idle, it would take 20min to enter sleep and enter off mode for further 5 hours.  If BT not connected, it enters off mode for 5 hours idle if no analog audio signal.​

​​

​​

2. What is the minimum threshold for keeping the speaker awake?

Without any signal for 20 minutes to the amp, it will go in to STBY mode (sleep), when input signal goes above -11.8dbu with tolerance +/- 1db.  ​The amp needs more than 10mW output to keep the speaker awake.

3. If in standby mode, is it true that you can only wake the speaker up by manually twisting any knob ​or pressing the bypass button?

If BT connected and enter standby mode, the way to wake up is BT streaming audio signal or by pressing power key. 

If BT not connected and enter OFF mode, the only way to wake up is to press power key. 

4. Is there any way to disable the auto standby function?

Try the following steps (User guide here, page 15)

Sleep (Auto On/Off)

The IRX100 has a Sleep feature to help maintain the life of the speaker and conserve energy.

To enable/disable the Sleep feature:

• Ensure the speaker is powered OFF.

• Press and hold the Power button for 5s until LEDs flash.

• If Sleep is disabled, the Power LED will light solid for 3s.

• If Sleep is enabled, the Power LED will blink for 3s.

Important Note: ​If there is no LED response from the speaker when attempting this process it means it has an old firmware and will require a firmware update (this update can only be done by an Authorized Service Center, for a locator click here). 

​

Bluetooth pairing and functions:

1. Bluetooth operation of IRX to pair a device to a single speaker: 

• Press the Bluetooth button for 2 seconds until the light blinks slowly. 

• Navigate to the Bluetooth settings of your device. 

• Select the IRX speaker you wish to stream to. 

• You will hear a connection tone when connection is successful. 

2. To​ pair a device in true stereo: 

• Press and hold the Bluetooth button on the 1st speaker until both the Power LED and the Bluetooth LED blink.  An audio cue will be heard.

• Repeat the process on a 2nd speaker. 

• After around 30 seconds, the speakers will pair to each other.  An audio cue will be heard. 

• Press the BT button again to pair your device to the 1st speaker only. 

• Navigate to the Bluetooth settings of your device.

• Select the single speaker you are attempting to pair to. 

• Speakers will now stream in TWS. ​

Note: For more information on this process inlcuding images, please click here (IRX True Wireless Stereo)

3. To exit TWS:

• Press and hold the BT button for 5 seconds until both the power LED and Bluetooth LED blink. 

• Press the BT button again. 

• The speakers are now unpaired.

4. To reset BT:

• Need to hold BT button for 5 seconds.​