​ Question: Can I cascade different types of DMM mixers?    Answer: No, different types cannot be cascaded.  You can.......

Question: Which parameters determine the automix algorithm? Answer: It blends dynamic level adjustment, Best Mic On selection and Noise Detect.......

Question: What ratio does the channel compressor use? Answer: The compressor works with a fixed 2:1 ratio; its threshold is.......

Question: Which variant supports Dante audio networking? Answer: The DMM14 ULD routes all inputs and outputs as 24‑bit/48 kHz channels on.......

Question: How much gain is available on each analogue input? Answer: Front‑panel gain knobs adjust from 0 dB to +60 dB in.......

Question: Is the headphone knob affected by System Control selection? Answer: No - the HEADPHONE encoder always remains in LEVEL.......

Question: Can the mixer be configured from a browser? Answer: Yes - the UL and ULD provide an embedded web.......

Question: What high‑pass settings are offered on the inputs? Answer: A second‑order filter sweeps from 0 Hz (off) up to 150 Hz.......

Question: How many mixers can I cascade for larger systems? Answer: Up to ten units can be chained, giving 60.......

Question: What is the difference between the DMM14 U, UL and ULD models? Answer: All three share identical audio features; UL.......

Question: How much delay can be applied to the main outputs? Answer: OUT 1 and OUT 2 each provide up.......

Question: Which channels feature the third‑octave equalizer? Answer: Graphic EQ is available on the two stereo outputs; input channels use.......

Question: How much mains power does a DMM14 draw? Answer: The built‑in wide‑range supply consumes a maximum of 75 W from.......

Question: How much advantage does the priority channel get in automix? Answer: A channel marked as Priority is evaluated 6 dB.......

Question: Which automation systems connect over the serial port? Answer: The three‑pin RS‑232 can load firmware and allows external control.......

Question: How do I capture a programmed mix from the DMM14? Answer: Use the fixed‑level unbalanced RCA pair labelled REC.......

Question: Can I adjust the master volume with an external potentiometer? Answer: Yes - a front Phoenix VCA port accepts.......

Question: Can I adjust the master volume with an external potentiometer? Answer: Yes - a front Phoenix VCA port accepts.......

Question: How many analogue sources can one DMM8 accept? Answer:​ Each unit provides six balanced XLR mic/line inputs with switchable.......

Question: Which elements make up the built‑in automix algorithm? Answer: The DSP combines Dynamic Level Adjustment, Best‑Mic‑On selection and Noise.......

Question: How large a system can I build by cascading DMM8 mixers? Answer: Up to ten units may be linked,.......

Question: What compression ratio is used on inputs? Answer: The channel compressor is fixed at 2:1 with a threshold adjustable.......

Question: Which audio is sent to Dante on the ULD model? Answer: All six processed inputs and both stereo sums.......

Question: How many graphic EQ bands are available on the stereo outputs? Answer: Twelve half‑octave bands can be boosted or.......

Question: Does System Control affect the headphone knob? Answer: No - the HEADPHONE encoder always stays in LEVEL mode regardless.......

​Question: What is the gain range on each channel’s rear‑panel trim? Answer: Rotating from fully counter‑clockwise to full clockwise adds.......

Question: Can I set up the mixer from a browser? Answer: UL and ULD versions host an embedded web interface.......

Question: How far can I lower the output limiter threshold? Answer: The limiter is adjustable from +20 dBu down to –25 dBu.......

Question: What range does the input low‑cut cover? Answer: The second‑order high‑pass sweeps from off (0 Hz) up to 300 Hz in.......

Question: How much acoustic delay can I set on the main outputs? Answer: OUT L and OUT R each provide.......

Question: What phantom‑power spec do the inputs meet? Answer: Every input can supply 48 V at up to 10 mA through dual.......

Question: How much mains power does the DMM8 draw? Answer: Its universal supply consumes up to 75 W from 100–240 V AC, 50/60 Hz.​....

​Question: How much louder does a priority channel appear to automix logic? Answer: Marking a channel as Priority gives it.......

Question: How do I route channels to the RCA record outputs? Answer: Activate Routing to REC per input; lit LEDs.......

Question: Within what ambient temperature can the DMM8 operate? Answer: The specified safe operating range is 0 °C to +50 °C with.......

Question: What does the USB port do? Answer: It acts as a class‑compliant stereo sound card, streaming two channels in.......

Question: What are the functional differences between DMM8 U, UL and ULD models? ​ Answer: All share the same DSP engine;.......

Overview: How to set up AKG DMM8 UL automixer to create a discussion system Procedure ​​​​1.      Choose the.......

​​​​The DMM's feature set and explains how to adjust its ​​DSP functions.....

​​​Covering the steps necessary for setting up a basic discussion system using a DMM automixer and several​​​ CGN321sts microphones.....