DXLink 4K60 TX Hotfix
Table of Contents
Brands:
- AMX
Models:
Product Name:
- DX-TX-4K60
SKU / FG #:
- FG1010-312-xx
Downloads:
Version: v1.8.5.99
Release Date: 10/22/2024
SW1010-312-0X_DX-TX-4K60_v1_8_5_99.zip
Note:
This zip only includes firmware for the copper TX only. If hotfix firmware for the fiber TX is needed, there is a separate help.harmanpro.com article available. dxlink-fiber-4k60-rx-and-tx-hotfix
There is currently no 4K60 RX Hotfix later than the released v1.8.5.
Information:
Changes in this release:
- Changed +5V video signal to improve video detection with certain devices that require a faster HPD (Hot Plug Detect) and exchange of EDID info. This could be used in the case of a rebooting or waking source that is not able to establish a good connection to the TX resulting in that source not sending video.
Programming Instructions:
- Load this v1.8.5.99 full kit to the copper TX
- When the firmware update is complete and the TX is back online, confirm the app version in the Online Tree is v1.8.5.99
?FWVERSION >> FWVERSION-ARM_V1.8.5.99 MCU_V9.7.1 EP_V6.1 VALENS_V7.4.44 SI9396_V1.3.02Optional:
If you need to factory reset the TX/RX to get it back to a known/default starting point, there are a few options:
- TELNET: “reset factory”
- NETLINX COMMAND: “FACTORYRESET”
- ID BUTTON: Press and hold the ID Button, apply power/POE to the TX/RX and continue to hold the ID Button. The front LEDS will flash a sequence about once per second. When they start flashing faster (approximately twice per second) let go of the ID Button and it will perform a factory reset. Holding it longer will cause it to revert to the initial factory firmware version.
Revision History:
Table of Contents