Using DCiDA Amplifiers in Dante Domain Manager
Technical Support Guide
Table of Contents
Brands:
- Crown
Models:
Product Name:
- DCi4x300DA, DCi4x600DA, DCi8x300DA
- DCi4x1250DA, DCi8x600DA
Prerequisites:
Latest DCiDA Amplifier and Dante Firmware
Information:
The AES67 setting for amplifiers in Audio Architect can be enabled or disabled while the device is enrolled in a domain. However, before enrolling the device, this setting must be configured to match the Dante Domain Manager setup.
If the AES67 setting does not match, Dante Domain Manager will attempt to change it automatically during enrollment. This action may cause the amplifier to reboot or experience unexpected behavior.
Setup Procedure:
Dante Domain Manager Settings
This parameter is found under the Domain Parameters within Dante Domain Manager.
Audio Architect Settings
For Amplifiers, this setting is found in the device control panel under the Input > Input Configuration > Advanced Settings section of the control panel. The Enabled LED should not be lit.
If this setting is changed offline, it will require going online and sending settings to the amplifier. The amplifier may also require a reboot after this setting is changed. This must be changed on each amplifier in the domain.