Brand:

• AMX

Models:

• Massio Control and Keypad

​MX Massio ControlPad and Keypad Default Info

The default login and IP information for AMX Controlpads and keypads (MCP/MKP-106/108) are listed below.

Username: administrator
Password: password

Default IP Configuration:

The MCP-106/108 are configured for DHCP by default, but they do have a default static IP address (192.168.1.3), and the IP mode can be changed to this using the steps below. There are two methods.

Method 1: 

You can toggle between the DHCP and Static IP modes by pressing the ID Pushbutton located on the bottom of the ControlPad. After the ControlPad boots, press and hold the ID Pushbutton for 10 seconds.

NOTE: You must wait until the ControlPad is finished booting before toggling the IP address. Pressing the pushbutton while booting will cause the ControlPad to restore its factory default settings.

When you release the Pushbutton, the ControlPads toggles either from static to dynamic (DHCP) IP addressing or vice versa and remains in that mode until the you use ID Pushbutton to toggle the IP mode again or you perform a factory reset. The ControlPad automatically reboots to complete the process.

Method 2: 

In place of using the ID pushbutton, you can press buttons 1 and 2 simultaneously on the ControlPad to simulate the functions of the ID pushbutton. You must keep both buttons pressed for 10 seconds as you would with the ID pushbutton to toggle between IP address modes.

Factory Reset Procedure:

Like the procedure to toggle between IP modes, there are two methods for a factory reset.

Method 1: 

To perform a factory reset of the ControlPad or Keypad: Press the ID pushbutton for approximately 10 seconds during the boot process. While pressing the ID pushbutton, disconnect and reconnect the cable from the LAN port on the rear panel of the ControlPad to reset the ControlPads factory defaults. During factory reset, the backlight turns off for all buttons, but all buttons should be back online after 1-2 minutes. If you do not hold in the ID pushbutton for the full 10 seconds, the reset does not occur. (There is no soft reboot with the ID pushbutton, but you can perform a soft reboot from the web pages.) On Massio ControlPads and Keypads, the LEDs on buttons 1 and 2 blink while you keep them pressed. Hold them until the LEDs begin blinking at double the rate (approximately 10 seconds.) Release the buttons and the keypad will reset.

Method 2: 

In place of using the ID pushbutton, you can press buttons 1 and 2 simultaneously on the ControlPad or keypad to simulate the functions of the ID pushbutton. You must keep both buttons pressed for approximately 10 or 20 seconds as you would with the ID pushbutton to perform a factory reset or restore the factory firmware image on the device. You must also disconnect and reconnect the cable from the LAN port while pressing the buttons. FIG. 14 displays the locations of buttons 1 and 2 on each Massio device.