Overview:

RUSH MH 5 Profile- Replacing Gobos

Replacing Gobos

t is possible to replace the rotating gobos with custom gobos that match the quality and specifications of the gobos supplied with the fixture. The rotating gobos can be replaced with custom aluminum gobos in the following size:  ​

Interchangeable Gobo Specifications

• ​​​Gobo size: 24 mm (0.94 in.) 
• Gobo image size: 20 mm (0.79 in.)  
• Gobo thickness: 0.3 mm 

*Gobos are exposed to thermal stress. Custom gobos must be constructed to the same quality standards as the original items.*   ​

​To replace a rotating gobo: 

1.   Disconnect the fixture from power and allow it to cool for at least 10 minutes.

2.   See illustration below. Remove the fixture head covers using a Phillips screwdriver.   ​

3.   The rotating gobos sit in gobo holders that slot into the rotating gobo wheel. Note the position of the gobo – you will need to reinstall it in the same orientation. Lift out the gobo holder that contains the gobo that is to be replaced.

4.   See illustration below. The gobo is held in place in the gobo holder by a wire clip. Taking care to avoid scratching or applying pressure to the gobo, remove the clip and lift the gobo out of the gobo holder.  

5.   Place the new gobo in the gobo holder and reinstall the wire clip. Check that it is clipped fully into its grooved seating and replace the gobo holder in the rotating gobo wheel in its original orientation.

6.   Replace the head covers and be ready for the head to move when the product resets when you reapply power.