Overview:

RUSH ​MH 10 Beam FX- Master/Client Operation

​Master/client operation

Fixtures in Show Mode can be linked in a chain and set to master/client operation, where one master fixture running a standalone show controls the behavior of client fixtures. Two client modes are available:

• Fixtures in Client 1 mode copy the master.
• Fixtures in Client 2 mode are synchronized with the master but have slight variations in behavior.

You must set all the fixtures except one as clients. If you set more than one fixture in the chain to act as master, you may cause damage that is not covered by the product warranty.

​​To operate fixtures in master/client mode:

1. Link fixtures in a chain, using DMX cable to connect one fixture's DMX OUT socket to the next fixture's DMX IN socket.
2. In the MASTER CLIENT menu, set one fixture to MASTER and set all the other fixtures to CLIENT 1 or CLIENT 2.
3. Set the master fixture in the chain to run one of its four standalone shows using its SHOW MODE menu (see Stand-alone operation​).
4. Set all the fixtures in the chain to DMX STATE > SHOW MODE.
5. Make sure that the fixtures are not receiving a DMX signal.