​​

RUSH ​MH 10 Beam FX- Stand-alone operation

​​Stand-alone settings

The fixture will operate in stand-alone mode if it is not receiving a DMX signal and the DMX STATE menu option is set to SHOW MODE (see DMX State), or if you enter the SHOW MODE menu in the control panel. Stand-alone show selection (Show Mode) Four pre-programmed stand-alone shows are available. 

To set the show that the fixture will run in Show Mode:

1. Select SHOW MODE and press ENTER to confirm. The currently selected show will blink in the display.
2. Use the DOWN and UP buttons to select Show 1, 2, 3 or 4.
3. Press ENTER to save your selection.