How to Setup Cascade Mode with Ui24r

To use cascade mode you will need the following items:

1.         Two Ui24rs (They both must be on the same firmware 3.x)

2.         3 Ethernet Cables

3.         Gigabit ethernet switch

Step One

1.         Log into the Ui24r designated as your primary Ui24r

2.         Select the settings gear

3.         Select the network tab

4.         Make note of the Ethernet IP address by default it is 10.10.2.1

5.         Log into the Ui24r designated as secondary Ui24r

6.         Select the settings gear

7.         Select the network tab

8.         If your Ui24r is on the default settings you will note that the IP address for the LAN port is 10.10.2.1. This will need to be changed.

9.         Select the config button (you may be prompted for a username and password by default this is admin/admin)

10.       Select LAN Configuration

11.       Change the IP address from 10.10.2.1 to 10.10.2.2

12.       Save the changes and reboot the Ui24r

Physical Connections

1.         Use ethernet port 1 from the primary Ui24r to the gigabit ethernet switch

2.         Use ethernet port 1 from the secondary Ui24r to the gigabit ethernet switch

3.         Use ethernet port 2 from the primary Ui24r and connect it to the secondary Ui24r Ethernet Port 2

Primary Ui24r

1.         Log into the Primary Ui24r

2.         Select the settings tab

3.         Select Cascade

4.         Turn Cascade on

5.         Select the Role of the primary Ui24r (primary or master)

6.         Input the secondary IP address (10.10.2.2) in the space below​