Anytime Help Center

Creating a Manual Ethernet Connection to the Soundcraft Ui

Rating

​Ui LAN Direct Ethernet Connection Set up


In order to create a direct Ethernet connection to your Ui mixer perform the following:


1. Connect to your Ui mixer via HotSpot.

2. Go to the Settings Menu
PIC01 arrow settings.png
3.Select the Network Tab
PIC02 arrow network.png
 4. Select the CONFIG button
PIC03 arrow config.png
5. You’ll be prompted to enter in a username and
password; default for both is “admin”
PIC04 config password screen.PNG
6. Once you’re logged in select the LAN Configuration
Tab
PIC05 LAN Config Manual.png
7. Make sure you enable the Ethernet port

8. Under the Address section select Manual mode

9. Enter in the following information for all the
required fields

 IP Address: 10.10.2.1

 Subnet Mask: 255.255.255.0

 Router: 10.10.2.1

 10. Be sure to Save/Update all these settings

11. Power cycle your unit.


Steps 12 - 17 are PC specific, MAC settings are steps 18 - 21 below:


PC Setup

12. Go to Internet Settings on computer: Start,
Control Panel, Network & Sharing Center.
PIC06 Network and Sharing Center control panel.png
13. Select Change adapter settings.
PIC07 Network Sharing center.png
14. Decide which local area connection you would
like to use (in this case, Ethernet). Right click and
select Properties.
PIC08 Network Adapter settings ethernet properties.png
15. Choose connection (usually Internet Protocol
Version 4).
PIC09 Ethernet Properties IPV4.png
Click Properties

 16. Make sure the IP Address is 10.10.2.5 (This
ensures that multiple devices can connect).
PIC10 IPV4 properties manual IP.png
17. Open web browser and type 10.10.2.1 into
address bar, should bring you to the “choose your
device” screen, click on the bigger tablet icon, and
you should be up and running.
 

MAC Setup:


 18. Go to System Preferences.

19. Select the Network icon.
PIC11 Mac System Preference - network.png 
20. Select the Ethernet connection and switch drop
down to “Manually”.
PIC12 Mac Network pref - Ethernet manual.png
21. Enter in the following information:

           Configure IPv4: Manually

           IP Address: 10.10.2.5

          Subnet Mask: 255.255.255.0

           Router: 10.10.2.1

PIC13 Manual IP address set and apply.png

Downloads

Product

Ui

Topic

Configuring

Related Articles

Last modified at 10/29/2020 10:20 AM by PRO Knowledge Base
Top