Anytime Help Center
Tech Support
Log In
Help Center
/
Replacing the microSD card in a MCP keypad
Replacing the microSD card in a MCP keypad
Rating
Technical Support Guide
Page Content
NOTE: If the keypad is installed and you need help disassembling or reassembling the MCP-108 or the MCP-106 please refer to the end of this document.
Step 1: Swapping the microSD card
Your MCP keypad should look very similar to the below picture. There may be tape over the microSD card. If there is tape, carefully remove the tape and set it aside, you will put it back over the new microSD card when you're done. Slide the old card straight out and slide the new card straight in, making sure it is seated all the way in. Put the tape back on if you removed it earlier.
Downloads
Related Doc 1
Replacing the microSD card in a MCP keypad.pdf
Related Doc 2
Product
Topic
Operational
Related Articles
Last modified at 7/2/2020 5:12 PM by
PRO Knowledge Base
×
Top