​​​Question:

How do I change what DSP is used in my configuration from the front panel?

​Answer:

From the front panel of your 260 do the following to add Subharmonic Synthesis &/or Noise Gate to the configuration.

1. Hold PROGRAM/CONFIG until the word "Configure" appears at the bottom of the display.
2. Press the NEXT PG button 2 times until "AFS" is shown in the display.
3. Rotate the DATA encoder clockwise until "SUBH" is shown.
4. Press the NEXT PG button once. Rotate the DATA encoder clockwise until "NOISE GATE" is shown on the display.
5. Push this sequence of buttons to load configuration changes: PROGRAM/CONFIG>DATA Encoder (push in)>DATA Encoder (push in).

To access Subharmonic Synthesis press OTHER and rotate the DATA encoder clockwise once to turn it on

To access the Noise Gate press DYNAMICS and rotate the DATA encoder clockwise once to turn it on

​​