​​​​​​Setup CobraNet Discovery

• Go to tools>Preferences>Check Enable SNMP
  

​

• Go to tools>Options>Select the network interface connected to the CobraNet Network.
  
• The auto assignment can be used in cases where the new paging station device doesn't have an IP address. This will enable a type of DHCP so be careful using that on networks where some devices use automatic/DHCP because this will hand out IP addresses.
  

Configure the Device

​​​​​​​Setting The Current IP

• Double Click on a device that you want to configure to open the interface
• Select SNMP
  

• Under the Group select Monitor
  
• Under the Variable select ipMonCurrentIP
• Selecting Get will pull the current IP address

• If you need to change the current IP address you can type it in and select put.
  

Setting a Static IP​​

• Select ipMonStaticIP under the variable
• ​Type in the IP address you want and select put.

Setting Persistance​​

Last Setup persistence on the device so that the device will remember the settings after being rebooted.

• Go to Advanced

• Make sure the persistence box is checked. Without this the device will not retain its IP address if the device is power cycled.    Note: Do not change the device name on devices because this will break communication of the CM-1 card with the host interface.